Close filters
 
  •  
from to
1 From 2
No results were found for the filter!
Hexagonal driver 12mm x 5.5mm
Hexagonal driver 12mm x 5.5mm
The hexagonal drivers made of pure aluminium are more solid than the mostly original drivers. The thickness corresponds to the standard of 5.5mm.
€6.49 *
Wheel hub nut for 1:8
Wheel hub nut for 1:8
These are standard aluminium wheel nuts for high tightening torques.
€1.50 *
Wheel spacer 20mm for 1:10
Wheel spacer 20mm for 1:10
The improved assembly strategy of this widening improves handling and stability. It is recommended to use screw locking lacquer or alternatively Teflon tape to secure the central screw on the axle against loosening. By widening the lane,...
€21.49 *
Hexagonal drivers 17mm
Hexagonal drivers 17mm
The hexagonal drivers made of pure aluminium are more solid than the mostly original drivers.
€7.99 *
Standard axle ball bearing set Reely 1:10
Standard axle ball bearing set Reely 1:10
Standard stainless steel bearing with water protection, 2-piece set complete for one wheel suspension (can be used at the front and rear), pre-greased.
€3.30 *
Hint!
Aluminium Differential 1:10
Aluminium Differential 1:10
The differential is completely mounted. The aluminium differential bell makes it very resistant and temperature resistant.
€29.90 *
Front steering knuckles
Front steering knuckles
Very stable steering knuckle with good bolting for high tightening torques. The grub screws must urgently be secured with RaguTite. Please also refer to our installation guide for the steering knuckles, with useful tips for successful...
€19.99 *
Wishbone bracket
Wishbone bracket
Bruchsicheres Fahrwerksteil aus Aluminium mit sehr stabilen Schraubgewinden für große Anzugsdrehmomente. RaguTite wird empfohlen, um die Schrauben zu sichern.
€9.98 *
Wheel spacer 15mm / 12mm-17mm adapter
Wheel spacer 15mm / 12mm-17mm adapter
The wheel spacers are especially optically absolutely convincing. They improve the look of the RC car and at the same time increase its safety against tipping in delicate driving situations. The RC Car is widened by 2 times 15mm, i.e....
€17.99 *
Front lower wishbone
Front lower wishbone
Aluminium part milled from solid material to reinforce the chassis Useful tips for installing these wishbones can be found in the installation guide.
€17.99 *
Steering linkage
Steering linkage
incl. servo saver, very robust and precise, aluminium milled solid material
€17.99 *
Track widening 30mm for 1:8 RC-Cars
Track widening 30mm for 1:8 RC-Cars
The wheel spacers are especially optically absolutely convincing. They improve the look of the RC car and at the same time increase its safety against tipping in delicate driving situations. The RC Car is widened by 60mm. These are...
€21.99 *
1 From 2
Viewed